Wrought iron
Wood & steel frame
Farm & ranch
Sliding driveway gates
LiftMaster operatorsFree on-site gate assessment - hinges, posts, and your LiftMaster or Nice gate operator checked before anything is quoted
The assessment is free and the quote is the invoice.
Get your free estimateGate Company in Fullerton, CA
Gate installation in Fullerton runs $2,800 to $11,000 for most residential jobs, depending on whether you’re adding a simple swing gate on a flat 92833 lot or an automated steel slider on a hillside in 92835. Fullerton’s housing stock spans 1920s downtown bungalows, mid-century ranchers, and custom foothill estates, which means no two gate jobs here look the same. We’re gate specialists, not generalists. That’s all we do. Call (833) 589-7839 for a free measure and a written price before any work starts.
Why Fullerton Homes Are Different
Fullerton’s gate-repair demand is shaped by its mix of pre-war downtown bungalows, mid-century tract subdivisions, and hillside estate lots in the 92835 and 92831 areas. The aging wrought-iron and wood driveway gates in these neighborhoods sit on pier-and-block walls that shift with clay soil. Fullerton clay swells in winter rain and shrinks during the hot, dry Santa Ana wind episodes, so a gate that latched fine in September can drag by February. The fix is often reshimming or resetting the post rather than replacing the gate itself.
Near downtown and the college areas, we routinely encounter gates built to old masonry-and-iron patterns that newer suburban cities simply don’t have. Original 1920s through 1950s homes have brick or block piers that have settled or rotated slightly over the decades. A wooden gate on redwood posts from the 1960s reacts differently than a 2005 steel frame on powder-coated posts. Then there’s the southern exposure: Fullerton’s summer sun bakes west-facing gates, warping wood panels and fading powder coat while winter rains swell the wood back. We plan for all of this on every install.
Styles & brands we work with
Our Main Fullerton Services
Most Fullerton homeowners call us for one of two gate problems: a gate that won’t open or close properly, or the electric operator that drives it has stopped responding. Here’s what each service covers locally.
Gate Repair in Fullerton
Gate repair in Fullerton means working on hinges, posts, latch hardware, and the gate leaf itself – often on original 1920s-to-1970s structures. We reset sagging posts, reweld cracked iron, replace seized hinges, and rebuild wood frames that Fullerton’s dry sun and wet winters have taken apart over the years. We tell you honestly whether a repair is worth it or replacement makes more sense. Gate Repair in Fullerton covers the full scope, including same-day calls for a gate that won’t close at all.
Electric Gate Repair in Fullerton
Electric gate repair in Fullerton is a core specialty, not an add-on. Whether you’re running a Viking, Ghost Controls, or DoorKing operator on a 1950s driveway or a modern FAAC on a hillside estate, we diagnose the actual brand in your driveway. Control boards, loop detectors, keypads, safety edges, motor assemblies – it’s all gate work. Electric Gate Repair in Fullerton explains our process and same-day availability for dead operators.
What happens when you call
- 1
A real person answersNo phone trees — you reach a local pro.
- 2
You get an upfront price rangeHonest numbers before anyone is dispatched.
- 3
A background-checked tech heads outLicensed & insured, dispatched right away.
- 4
You approve before work beginsNothing starts until you say go.
Gate Installation in Fullerton
Gate installation in Fullerton means matching a new gate to the era of the house, the clay soil, and the Santa Ana exposure. Older homes often need new posts set in concrete before a gate can hang straight; hillside 92835 properties usually need a steel frame and a high-torque operator to handle the grade. We build for decades, not seasons, and the price is agreed before we order anything. For the full scope of what we install, see Gate Installation.
Automatic Gate Installation
Signs you need it
You’re getting out of the car to open the gate every time, or an existing operator has failed and you want a system built for Fullerton’s climate rather than another patch job.
What it costs in Fullerton
Automatic gate installation in Fullerton typically runs $3,500 to $9,000, with operator choice and post work as the main variables.
How we do it
We set or repair the posts, hang the gate, mount the operator (residential lines like LiftMaster or Mighty Mule, or pro-grade FAAC/BFT/DoorKing for heavy traffic), run the power and safety edges, and program remotes and keypads.
Driveway Gate Installation
Signs you need it
The current gate drags on the driveway because the posts have shifted with Fullerton clay, or there’s no gate at all and the driveway opens straight to the street.
What it costs in Fullerton
Driveway gate installation in Fullerton runs $2,800 to $7,500 for a single swing gate, more for a slider or a pair of leaves.
How we do it
We measure the opening and slope, set new steel or wood posts in concrete, hang the leaf, and adjust the hinges so the gate holds its line through wet winters and the driest Santa Ana weeks.
Sliding Gate Installation
Signs you need it
The driveway slopes up from the street, or the setback is too tight for a swing gate, so a rolling or cantilever slider is the only option that won’t bind.
What it costs in Fullerton
Sliding gate installation in Fullerton typically runs $4,500 to $11,000 with the track, rollers, and operator included.
How we do it
We set the track or cantilever footing, build the gate to the exact opening, fit the rollers and guide, then motorize it and tune the limits and safety stops.
What Gate Installation Costs in Fullerton
| Item | Typical range in Fullerton |
|---|---|
| Manual swing gate, standard steel or wood | $2,800 – $5,500 |
| Automated swing gate with operator | $3,500 – $9,000 |
| Sliding or cantilever gate with operator | $4,500 – $11,000 |
Do you handle the power run and safety edges?
Yes. Every automatic gate installation includes the low-voltage power run from the nearest source, photo-eye or contact safety edges where code requires, and the receiver/remote programming. We don’t leave a motorized gate without its safety circuit functioning.
Is a permit required for a new gate in Fullerton?
Some Fullerton gate projects need a permit, especially anything with a new electrical run or a gate over seven feet. We can tell you on the measure visit whether yours qualifies. Call (833) 589-7839 and we’ll come out, measure, and give you a written price.
Brands We Service in Fullerton
We service nine gate operator brands, and in Fullerton that means a lot of Viking and Elite on older residential gates, Ghost Controls on newer DIY-adjacent installs, and DoorKing or FAAC on commercial and high-cycle entrances. We stock common boards, remotes, and safety parts locally, which makes most repairs same-week rather than ship-and-wait. Our brands page covers the full line.
See the difference
Before
After
Before
After
Before
AfterPricing for Gate Company in Fullerton, CA
| Service | Typical range in Fullerton |
|---|---|
| Gate repair (hinge, latch, alignment) | $150 – $450 |
| Post reset or reinforcement | $300 – $900 |
| Electric gate repair (board, receiver, safety) | $250 – $800 |
| Operator replacement (residential) | $800 – $2,500 |
| Operator replacement (commercial) | $2,500 – $8,000+ |
| Manual swing gate install | $2,800 – $5,500 |
| Automated swing gate install | $3,500 – $9,000 |
| Sliding gate install | $4,500 – $11,000 |
| Keypad, loop, or intercom replacement | $250 – $900 |
Fullerton prices push toward the top of these ranges when posts have to be dug out of old concrete footings, the gate is on a steep 92835 slope, or the operator is a commercial DoorKing that needs a new loop and board. Whatever we quote, the figure is agreed before we start – no open-ended labor.
Neighborhoods We Serve in Fullerton
We work all of Fullerton’s gate stock, from the original Craftsman and Spanish Colonial bungalows near the downtown and college districts to the ranch tracts on the east side and the custom foothill homes in 92835. Our most common call areas:
- Downtown and the college neighborhoods – original brick and block piers, older ironwork
- Raymond Hills and the hillside streets of 92835 – steep grades, heavy operators, steel sliders
- East Fullerton ranch tracts – 1950s-1970s homes with aging redwood and steel gates
- Sunny Hills – larger lots, long driveway gates, masonry posts
- The 92832 and 92833 flatland streets – clay soil post movement, wood warping
We’re in Fullerton most days of the week. A gate that won’t latch or an operator that won’t respond usually gets looked at same-day or next morning.
Service Area – Cities Near Fullerton
Ironcrest Gate Repair is based in Anaheim and covers Fullerton plus the surrounding North Orange County cities. If you’re just outside Fullerton, we also serve Anaheim, CA, La Habra, CA, Placentia, CA, and Brea, CA. Call (833) 589-7839 to confirm we cover your street.
Serving Fullerton, CA — Our Local Coverage Area
We’re based in the Fullerton area and know this community well. Use the map below to see our service coverage — if you’re nearby, we can almost certainly help.
FAQs About Gate Company in Fullerton
For repair calls – a gate stuck open, an operator with no power, a latch that won’t hold – we can usually get a technician to Fullerton the same day or next morning. Installation and full replacements are scheduled around a measure visit and parts order, but the measure itself is quick to book. Call (833) 589-7839.
We’ll provide the specs, materials list, and drawings your Fullerton HOA asks for. The approval filing itself usually sits with the owner or manager, since HOAs want the homeowner’s signature. We’ve worked with most of the Fullerton associations around 92835 and know what they’ll ask for.
That’s most of what we do. A sagging gate, a dry-rotted wood section, a keypad that works intermittently, hinges that squeal or bind – these are repair jobs, not replacement jobs. We’ll tell you straight if the gate has life left. Call (833) 589-7839 for a free estimate.
Ironcrest Gate Repair has served Fullerton since 2017. We work on gates, operators, and nothing else. If your Fullerton gate is dragging, dead, or simply old, call (833) 589-7839 and we’ll send a gate specialist, not a generalist.
What happens when you call
- 1A real person answersNo phone trees — talk to a local gate repair pro.
- 2You get an upfront price rangeHonest numbers before anyone is dispatched. No surprises.
- 3We come out and measureLicensed & insured, at a time that suits you — the visit and the quote are both free.
- 4You get the price in writingLine-itemed, yours to keep, and nothing starts until you say go.
What Fullerton Customers Say
"The loop detector under the driveway had failed and residents were stuck holding the button. He traced it, found the break, and had the exit loop reading cars again the same visit."
— Norma Garcia"Repair is holding. He was quite a bit later than the window I was given, and the office didn't call me about it, I had to call them. The work itself was done well once he got here."
— Craig Kowalski"Fixed the immediate problem. He was honest that the operator is near end of life and I should budget for a replacement, which I appreciate even if it wasn't what I wanted to hear."
— Andres Flores